USER MANUAL SurgeX XR315 SurgeX® For Surge Eliminator Residential Applications Software Version 1.0/1.1
10 Over-Ride Input Select “Contact Closure” if a relay or switch is used, or “5-30V dc” if a DC voltage is used. Over-Ride Func This selects the f
11 5.4 Auxiliary Relay The programmable auxiliary relay provides a single normally-open contact which is available at the rear of the unit. The aux
12 5.6 Out-of-Range AC Voltage Shut Down The XR315 has built-in line voltage monitoring and out-of-range shut down. The default limits are 90V at t
13 6.1.1 Controlling the XR315 The XR315 is primarily designed to be used with momentary action switches. A momentary switch is a switch where the
14 The aux relay has a special use when XR315s are ganged or cascaded together – this is covered in the sections on ganged and cascaded systems. 6.1
15 6.2 Single Unit System Most of the information necessary to install and set up a single unit system can be found in sections 3.2 and 6.1. Figure
16 The remote control inputs should be connected to the first unit, and the same control options are available as for a single-unit system. If confi
17 Receptacles 1 2 3 4 5 6 7 XR315 Single-Unit System Controlled by Momentary Switches Loca
18 Receptacles 1 2 3 4 5 6 7 XR315 Mixer Signal Processing Amplifier Single-Unit System C
19 Expanded System Using Aux Relay Receptacles 1 2 3 4 5 6 7 XR315 A-On Switched 1 2 3 4 5 6 7 SX1120-RT LED and 1K, 1/4W Res
2 1 DESCRIPTION ...
20 Expanded System Using 12V dc Output Receptacles 1 2 3 4 5 6 7 XR315 A-On Switched 1 2 3 4 5 6 7 SX1120-RT Confirmation (If
21 Three Units Ganged Together Receptacles 1 2 3 4 5 6 7 XR315 Receptacles 1 2 3 4 5 6 7 XR315 Receptacles 1 2 3
22 Three Units Cascaded Together Receptacles 1 2 3 4 5 6 7 XR315 Receptacles 1 2 3 4 5 6 7 XR315 Receptacles 1 2
23 7 Troubleshooting Initial Check Whenever power is applied to the XR315 the LCD display should be illuminated and should show two lines of text
24 The unit starts to power up but then immediately powers down There are two likely causes for this: One cause is a Down input that is on all the t
25 9 Specifications Operational Voltage Range: 90 to 150 Volts AC Current rating: 15 Amps Power Rating: 1,800 Watts Maximum Load Inrush Energy:
3 1 Description The SurgeX® XR315 is a 120V, 15 Amp AC power quality product incorporating SurgeX® Advanced Series Mode® power conditioning and su
4 A plug-in Phoenix terminal block on the rear panel accommodates the remote control connections and also the low-voltage outputs. There are three in
5 tap. *CAUTION: Do not install this device if there is not at least 10 meters (30 feet) or more between the electrical outlet and the electrical se
6 b) Contact Closure: The XR315 will power up when the contacts are closed and power down when the contacts are open. Connect the two wires from the
7 Program the 12V dc Output for “LED”. This causes LEDs connected to the XR315 to flash while the unit is powering up or powering down in the same ma
8 4 Quick Start This section is intended to allow users with a simple straightforward system incorporating a single XR315 to get up and running with
9 5 Programming The XR315 is a very versatile product and has 16 menu items that control its operation. Some menu items allow predetermined options
Kommentare zu diesen Handbüchern